Use Of Peanut Hydraulic Oil Press
Use of peanut hydraulic oil press
Peanut hydraulic oil press is suitable for pressing sesame. It also relies on pure physical pressing. And the output of each pressing is small, suitable for the use of small amount of sesame. Steps to use hydraulic oil press.
Inspection and debugging of peanut hydraulic oil press
1.1 Before the oil pump test, first add clean mechanical oil or vegetable oil to the oil tank, and press the handle up and down to see if the piston of the hydraulic oil press rises. If the piston does not rise or the handle does not take much effort when pressing, check each of the oil tanks. Valve, and exhaust the air in the pipeline.
Peanut hydraulic oil press
1.2 Carry out the pressure test of the whole machine, the pressure used in the test is 1.25 times the working pressure, check that the piston extends to a larger working stroke, stabilize the pressure for 15 minutes, and the pressure gauge reading should not exceed 4% of the test pressure. All oil There should be no leakage in the road. After all the presses are removed, the pressure gauge pointer returns to the "0" position, the parts are not damaged, the tie rods must not be significantly deformed, and the moving parts are not stuck.
Operation of peanut hydraulic oil press
2.1 According to different oils, master the squeezing temperature and moisture of the oils.
2.2 When pressing, move the lower top plate to the ground position, loosen the movable tie rod nut, pull out the two movable pins, and turn the movable tie rod to one side. After the cake is loaded into the press chamber in turn, the movable pull rod is turned back to the original position and fixed, and the pre-squeezed until the oil is seen, then the piston is returned, and the remaining cake is loaded for formal pressing.
2.3 When pressing, the handle should be lightly pressed and pressed evenly, and no excessive force is allowed, otherwise, accidents are prone to occur.
2.4 If it is found that the pointer of the pressure gauge does not return to the zero position during work, it should be checked, repaired or replaced in time.
2.5 Open the oil return valve, the oil will automatically flow back to the oil tank, the piston will automatically fall, and the squeeze can be unloaded.
