Precautions for the use of automatic oil press

Precautions for the use of automatic oil press

Matters needing attention in the use of automatic oil press

1. The dry humidity and temperature of the oil should be suitable before being pressed. Different oils should be treated differently before being pressed.

2. After finishing the preparation work before pressing, screw the screw shaft to the dead point, and then return it for 3 to 4 turns to ensure that there is a certain gap at the cake outlet, otherwise the body will burst due to sudden feeding and no cake. . ,

3. When the press is started, the output and oil yield are not high due to the cold body, and when the standby temperature reaches 100℃ (the outside of the body is hot), it can work normally. The pressing temperature can be adjusted according to the pressing oil.

4. When the machine is shut down for a long time (above 1h), the residual cake in the chamber should be cleaned up and ready to be pressed again.

5. After each raw material is squeezed, it is necessary to put the oil cake and walk the material again to ensure that there is no raw material in the press chamber, and then shut down.

The above matters need to be mastered. Avoid such and other problems during use, which will affect the oil output rate and life of the machine.