Running in your new screw oil press

Many consumers don’t know that each new machine in addition to installation and debugging, but also for its adequate running-in screw oil press . For any mechanical equipment, the running-in period is crucial. Screw oil press in the production process of failure rate, work efficiency and machine running-in has an inseparable relationship. Correct machine operation steps, especially the first step of the grinding steps, have an important impact on the machine life, oil output efficiency.

Then how to running-in the new screw press machine, which is mainly divided into the following 4 steps: step 1, adjust the gap between the screw shaft of the screw press and the cake output ring; step 2, let the screw press start idle for 3-5 minutes; step 3, press out the cake and feeding in batches; step 4, shut down to clean the screw oil press.

Of course, we need to pay attention to many small details in the process of the mill. Careless slightly will make the machine running-in inadequate or even the machine breakdown. For example, before using the screw oil press, we should first check the sealing condition of the sealing strip of the oil filter system, confirm whether the feeding belt of the feeding system is tight, and whether the press rod of the oil press system is concentric. Besides, at the beginning of the feeding can not add too much, otherwise the pressure of the squeeze chamber is too large, easy to cause the squeeze chamber jam or even card machine. Therefore, it is only suitable for a small amount of materials at the beginning, and then gradually increase to make the oil screw press running-in test. During running-in, it is forbidden to feed too fast, and try to grasp the feed by hand, so as not to cause stuffy machine.

So how to check whether the running-in is successful? We can do this by looking at the cakes. If the cake is tile shape, and the cake soon becomes hard after falling.It shows that the cake is normal. If the moisture is too high, the cake will be soft and limp, with spray on the cake.If the water is too moisture, the cake mouth will be sprayed with powder and the cake will be dark in color with a burnt taste. In addition, when the moisture of raw materials is too high or too low, the position of oil will move.

Read this, I believe that you have a certain understanding of the matters needing attention in the running-in process of the newly bought screw oil press. If you want to know more about the oil press, you can pay attention to our official website.