How to filter the oil filter of the oil press manufacturer
The oil squeezed out by the oil press needs to be filtered before it can be used. So how does the oil filter work? Today I will introduce to you how the oil filter of the oil press manufacturer filters.
When the oil filter is working, the filtered oil needs to be sucked into the strong magnetic filter under the external atmospheric pressure and the action of the vacuum pump, through the filtering of larger particles of impurities, the oil is heated by the heater, and then enters the multi-stage coalesced water filtration The water filter is used to strengthen the lipophilic and hydrophobic technology, improve the interaction force of the oil-water two-phase interface, accelerate the movement of small droplets of oil, and together form large droplets of oil precipitation, which are deposited in a pure water container, and qu removes The impurities in the oil enter the three-dimensional vacuum flash tower. After the spray device, the oil forest on the flash hood ring makes the oil produce a larger aeration process area and a longer residence time, which is full of the oil and gas separation process. Remove trace moisture remaining in oil and gas.
Evaporated water vapor, water vapor, light hydrocarbons and other gases pass through the wind condensing equipment, the water vapor and compressible gas are concentrated, the incompressible gas enters the vacuum buffer chamber, and the cooled water is directly discharged into the drainage device through the vacuum pump Condensable gas emissions. The oil in water, gas, and mechanical impurities is fed into the precision filter by the oil pump. The particulate impurities in the oil from the precision filter are cleaned by the oil filter to complete the entire purification process.
The maintenance of the plate and frame oil filter of the oil press manufacturer and the full technology of an
1. Always keep the machine clean.
2. The filter frame of the filter plate is fragile, so gently remove it when using it.
3. Do not push the oil filter too fast, so as not to violently impact the machine and damage the equipment.
4. Lubricating oil should be added to the compression nut frequently.
5. When using the oil filter, the motor housing should be grounded to prevent poor insulation from the motor.
6. The connecting bolts of each bracket of the motor should be checked regularly to prevent loosening.
If insufficient oil filtration is found, the following five aspects should be checked:
(1) There is air leakage in the suction pipe, strainer, oil inlet valve and joints.
(2) The passing length of the suction pipe (generally no more than 5m) or the pipe diameter does not meet the requirements.
(3) Whether the water inlet pipe and coarse filter are blocked.
(4) Whether there are other attachments in the suction pipe, causing excessive resistance.
(5) Gear pump an all valve is loose or loose.
