The Basic Operation Process Of The Oil Press Manufacturer Introduced The Hydraulic Oil Press
What is the basic operation process of hydraulic oil press equipment? What equipment does it have?
Each oil cycle includes (steamed) cakes, cakes, cakes (three stages: quick pressure, slow pressing, dotted oil), five steps, and planing.
(1) Steamed and cake hydraulic press oil is characterized by the molding of the material embryo and the insulation of oil and the insulation of the workshop. Oil also needs pre -processing, rolling and steaming. Different from other oil -producing methods, steamed mature embryos need to form cakes, which can be stacked before effectively suppression. (1) Steamed and cake hydraulic press oil is characterized by the molding of the material embryo and the insulation of oil and the insulation of the workshop. Oil also needs pre -processing, rolling and steaming. Different from other oil -producing methods, steamed mature embryos need to form cakes, which can be stacked before effectively suppression.
Cake production methods are divided into three types: manual, semi -machinery and machinery. In addition to the elimination of handmade cakes, some millet bran oil plants are currently using semi -mechanized steam cakes, camcakes, and spiral cakes; "The five major integration mechanization and continuous production. For example, the jaw -type SBY.35 hydraulic device automatic cake machine has the advantages of continuous cake, high efficiency (4 ~ 6 tablets/minute), low heat loss, low labor intensity. It has been adopted by most hydraulic engine oil plants.
Cake production requirements:
(1) The cake should be strong and resistant, the pressure is uniform, and the middle is slightly higher than the surroundings.
(2) A circle of pancakes, there is a perforated board squeezing the oil between the cakes.
(3) Fast cake, one formed at one time to prevent the loss of heat.
(4) It is required to use a vertical pressure machine. When the cake is filled, it should be flat and neat, and it must not be skewed.
(2) The hydraulic machine includes two parts: oil press (vertical or horizontal) and hydraulic system operation
Each squeezing process is divided into three stages: fast, slow squeeze and leaching. The main points of the operation are rapid oil output in the early stage, low pressure first, then high pressure, and then stabilizing oil. After the pressure is opened, once the oil is produced, it is necessary to "diligently top, light pressure, and relax", and there must be rhythm. When the pressure rises to high, the pressure needs to be stable so that there is enough time to discharge oil.
Oil press equipment
(3) After the hydraulic oil presses, the "shaved side pressure", and after the insulation of the workshop, the cake edge is easy to suck the oil and affects the residual oil. The tight pressure of the hydraulic machine can cause temperature and water loss, so the insulation and moisture -proof of the workshop are very important. The general temperature is above 30 ° C, and the relative humidity is about 65%to 70%. This shows that the labor conditions are poor. After the unloading, "planing suppression" and the insulation and unloading of the workshop, the cake edge is easy to suck the oil and affects the residual oil, so it usually needs to be "plane suppression". The tight pressure of the hydraulic machine can cause temperature and water loss, so the insulation and moisture -proof of the workshop are very important. The general temperature is above 30 ° C, and the relative humidity is about 65%to 70%. This shows that the labor conditions are poor.
